Installing Aluminum Driveshaft on a 2001 Ford Mustang GT Bullitt

A collection of random how to articles that I've compiled. The sky is the limit.
Post Reply
southhawkct
Site Admin
Posts: 388
Joined: Sun Oct 05, 2014 9:29 pm
Status: Offline

Installing Aluminum Driveshaft on a 2001 Ford Mustang GT Bullitt

Post by southhawkct »

Disclaimer! Warning this is to be used as a guide and I will not be held responsible if anything goes wrong or you break anything. DO THIS AT YOUR OWN RISK!


Installing Aluminum Driveshaft on a 2001 Ford Mustang GT Bullitt
Installed on: 5/25/2002
Total Install time: 2 hours



Photo one:
Here's a photo of 2001 bullitt #2610 all jacked up and ready for her install
Image


Photo two:
Here's a pic of the new driveshaft on top and the old driveshaft on the bottom.
Image

Photo three:
Here's a pic of the tranny when the stock driveshaft is removed.
Image

Photo Four:
Here's another pic of the stock D/S removed at the rear axle.
Image




Photo Five:
Here's the final product installed. Overall it was fairly easy mod to install. Getting the yellow dot on the rear axle to line up with the yellow dot on the driveshaft had to be the hardest part.
Image
---
South Hawk Computing LLC Owner :ugeek:
Any advice / recommendations given on this forum should ONLY be preformed at the user's own risk. South Hawk LLC does not offer any guarantees or warranties when a user attempts to try these fixes on their own. We are NOT responsible for any damages that may or may not occur to your devices. :geek:

Post Reply